RK008 Bluetooth stopped working

hotswank

Yesterday I encountered midi sync problems when BLE was set to IN: the drumcomputer starts but stops immediately. Today I'm investigating if I have a midi clock loop and BLE no longer works at all.
Is there a way to (factory) reset the BLE or RK008?

EDIT: I did not try to sync over BLE, my FPI Multiclock does this flawlessly.

EDIT2: After numerous on and offs and the last time holding MODE while pressing STOP to turn it on, BLE was active again. Don't understand what I did or why it did. Could it be the RK008 is very sensitive to static electricity caused by rubber footwear and nylon cloths? In the past it happend twice when I touched it, it suddenly shut down and rebooted by itself. This was during USB power, not the battery.

Andrew J

hotswank That has happened to me, though I also have long hair and am prone to a lot of static haha. I constantly am shocking things and people around me its annoying. But yea, noticed it happens when it's plugged in via usb.

grit

hmm, BLE can be a bit 'temperamental' with connecting, disconnecting and storing previously connected devices but the reset because of static is not something I have heard of earlier. I can try and invoke some static on units here to test. Perhaps it is more a problem caused by a USB ground loop? Perhaps a USB-USB isolator could solve this - maybe you can pin it down to a specific device connection.